Home>Popular Page

Plastic mold industry with their development needs in addition to foreign advanced levels, mainly in 6 aspects.

1. Progress is uneven, lower complete level of product. Although individual company's products have a very high level, some of the products of man or women enterprises at or close to the international level, nonetheless overall, the accuracy in the mold, the cavity surface roughness, production routine, life and other indicators and also the level of foreign advanced still larger approach gap. Including generation and business supervision, including the overall degree of foreign industrial countries you will discover more than 10 years compared to the gap.

2. Backward technologies and equipment, very poor organization and coordination. Although some of the technological transformation of enterprises in the last few a long time, has more superior technology and products level, but almost all companies are nonetheless relatively backward technologies and equipment. A lot more important is some of our business organization in addition to coordination ability, good difficult to assimilate or mobilize cultural resources for some of our use, which would be difficult to attempt large projects.

3. Most of the companies to develop fragile. The one side, the low ratio of technical workers, the level is not high enough, another is a smaller sized research and progress is more important will be the concept behind the development is not enough attention.

4. Management even more than technological backwardness guiding. Technological backwardness is normally easy to make sure management is sometimes difficult to understand that behind. Die at your home and abroad about business management is quite obvious gap, the gap among management problems tend to be caused by rather more serious than the technologies gap.

5. Market demand, production and progress were unable to keep up, were unable to resolve the contradiction among supply and demand, the supply circumstance will continue for quite a while, particularly conflicts in the more prominent high-end products.

6. Institutional and workers problems still that they are. In the socialist market economy, the approach to economic globalization, cut-throat industry, especially because the mold is so dependent on the particular individual, is single generation industry, many companies existing system and operating mechanism is still very difficult to adjust to changing market. Quantity and excellent of talent degree of the rapid development in the industry can not continue. Although the country are working to resolve these kinds of two problems, but still to buy a better solution.

Wanting ahead, the international in addition to domestic macroeconomic environment is normally good, the domestic plastic molds the many major user industries will always move faster pace, plastic molds will sustain and rapid development. The main problem existing domestic in addition to international exchanges in addition to cooperation through, in the joint efforts in the industry, through the joint support of all aspects, will gradually obtain better solution.